casting solution中文是什么意思

• 铸膜液

• "casting"中文翻译    n. 1.投，掷。 2.【冶金】铸造；铸件。 3.【动物 ...
• "solution"中文翻译    n. 1.溶解；溶液，溶体，溶剂。 2.(补轮胎用的)橡 ...
• "a casting" 中文翻译 :    铸件补缩
• "casting" 中文翻译 :    n. 1.投，掷。 2.【冶金】铸造；铸件。 3.【动物；动物学】脱弃，脱落物〔如毛、皮等〕。 4.计算。 5.想法，手法。 6.(木材等的)翘曲。 7.【戏剧】配角。
• "casting by" 中文翻译 :    选派演员
• "casting on" 中文翻译 :    起编; 修补浇铸
• "casting-in" 中文翻译 :    浇合
• "casting-on" 中文翻译 :    浇补 补铸; 修补浇铸; 修整浇铸
• "a solution" 中文翻译 :    从未准时的解决方案
• "a-solution" 中文翻译 :    素仙露
• "at-solution" 中文翻译 :    双氢速甾醇溶液
• "in solution" 中文翻译 :    溶解着; 在溶解状态中, 在不断变化中, 动摇不定
• "solution" 中文翻译 :    n. 1.溶解；溶液，溶体，溶剂。 2.(补轮胎用的)橡胶水；〔美国〕药水。 3.解决，解答 (of; for; to); 解释；(数学等的)解法，解式。 4.免除，解除。 5.【医学】消散，消退。 a nitrate of silver solution 硝酸银溶液。 chemical solution 化学溶解。 mechanical solution 机械溶解。
• "drain casting; hollow casting" 中文翻译 :    空铸法
• "pressure casting (die casting)" 中文翻译 :    压力铸造
• "slurry-casting casting" 中文翻译 :    粉浆浇注
• "acidproof casting" 中文翻译 :    耐酸铸件
• "air casting" 中文翻译 :    大气铸造
• "alloy casting" 中文翻译 :    合金铸件; 合金铸造
• "aluminium casting" 中文翻译 :    铝铸件
• "aluminum casting" 中文翻译 :    铝模铸造; 铝铸件; 铸铝
• "annealed casting" 中文翻译 :    退火铸件
• "anode casting" 中文翻译 :    阳极铸造
• "apparatus casting" 中文翻译 :    综合仪器箱
• "arch casting" 中文翻译 :    浇筑混凝土拱

• Influence of the temperature of pu casting solution on the breathability of coating fabric
  聚氨酯涂层液温度对涂层织物透湿性的影响
• Specification for castings of aluminium - silicon - magnesium alloy , chill cast solution treated and precipitation treated to an overaged condition
  冷铸用铝-硅-镁合金铸件规范
• Specification for castings of aluminium - silicon - magnesium alloy , sand cast solution treated and precipitation treated to an overaged condition
  砂型铸造用铝-硅-镁合金铸件规范
• The effects of pes concentration and temperature in casting solution on the structure and properties on pes ultrafiltration membranes are studied
  研究了铸膜液中聚醚砜的质量分数和温度对膜结构与性能的影响。
• Based on former studies , the effect of low licl concentration in casting solution ( w ( licl ) ) on membrane structure and performance was studied
  在前人研究的基础上,着重研究了铸膜液中无机添加剂licl的浓度( w ( licl ) )较低时对pvdf膜性能和结构的影响。
• The optimized process parameters are : the concentration of casting solution is higher than 9wt % , casting speed is 0 73m / min , temperature of wash bath is 45 and post - treatment is used
  当铸膜液浓度在9wt以上，刮膜速度为0 . 73m min ，水洗浴温度为45 ，并增加热处理和塑化处理时，膜的分离性能较好。
• With a decreasing cellulose concentration of casting solution or an increasing temperature of coagulation bath , the mean pore ssze becomes larger , resulting in higher pure water flux and lower rejection of bsa
  随着铸膜液浓度的降低或凝固浴(纯水)温度的升高，膜的水通量有较大的提高，但截留率会明显下降。
• With an increase of nmmo concentration of coagulation bath or concentration of casting solution , the crystallinity of membrane increases . however , an increase of temperature of coagulation bath is accompanied by a decrease of crystallinity of membrane
  膜的结晶度随铸膜液浓度、凝固浴浓度、刮膜速度的增加而增大，随凝固浴温度的升高而降低。
• The effect of casting solution compositions and preparation conditions on membrane structure and performance was discussed . modern instrumental analysis was used to investigate the membrane surface , cross - section and inner section
  探讨了铸膜液组成及制备条件对膜性能和结构的影响,并采用现代仪器分析手段对膜的表面、截面和内部结构进行了研究和分析。
• Using molecular imprinting method , the 1 , 3 - dimethylxanthine theophylline , tho molecular recognition membranes , containing an segments as membrane formation sites and aa segments as functional sites , were prepared by the phase inversion technique . here , tho was selected as a template molecule . the hydrogen bonding between aa segments and the tho templates was measured by ft - ir and nmr . the tho templates can be removed from the membrane through washing with acetic acid aqueous solution . the permeation of tho through the membranes is far more than that of 1 , 3 , 7 - trimethylxanthine caffeine , caf , which demonstrated the function of tho molecular recognition of the membrane . the results also show that the increase of the tho templates concentration in the cast solution caused an increase of tho amounts taken into the copolymer membrane
  Ft - ir及nmr测试结果表明：制备的高分子膜中， tho模板分子和膜中的丙烯酸功能残基存在着氢键键合作用。大量的极性醋酸水溶液可抽出膜中的模板分子。 tho溶液和与模板分子具有相似结构的1 ， 3 ， 7 -三甲基黄嘌呤咖啡因， caf溶液的基质透过实验结果：进入膜结构中tho分子的量远大于caf分子，这表明制备的高分子膜具有tho分子识别功能。